• 8d14d284
  • 86179e10
  • 6198046e

News

What Work Should Be Done When Using The Laser Leveler?

In recent years, with the continuous improvement of the construction requirements of the floor and pavement, there are also high standards for the construction quality of the ground and pavement. Under the premise of high standards and strict requirements, traditional manual construction can no longer meet the high-quality construction effect of the ground. At this time, many construction units will use laser levelers to perform construction on the ground to meet the requirements and effects of the construction party. What work should be done when using the laser leveler for construction? The following is a brief introduction from the laser leveling machine manufacturer.

First of all, the foundation of the construction ground must be thoroughly treated, and the laser leveler must be debugged. The original construction datum point must be used as a fixed construction datum point. Find a suitable place on the construction site, set up laser transmitter equipment, and input various ground data into the laser leveler according to the construction reference point. Do these preparations before ground construction, which is conducive to the full development of later construction.

After the concrete required for construction is transported to the construction site, the elevation must be checked and verified. In order to ensure the accuracy of the verification and verification data, it is necessary to correctly use the handheld receiver for verification, and then introduce the elevation data into the laser For the leveling machine, adjust the reference point of the laser leveling machine, so as to ensure that the laser leveling machine will not deviate during the construction process, avoid construction errors, and affect the final construction effect and construction quality.

Here to remind the majority of construction units that in order to ensure the quality of the ground construction, it is necessary to manually pave the concrete on the surface of the floor base, and there are certain requirements for the thickness of the concrete paving, which is about 2 cm higher than the floor, and then use laser leveling. The machine performs a one-time compaction and leveling work on the ground. In addition, after the initial setting of the concrete, the ground is polished with a polishing machine, and then the ground is polished and polished manually, so as to ensure the smoothness of the ground.


Post time: Apr-09-2021